Blue Neon Flex Double Side 220V 240V 120LED/m 8x16mm IP65 Waterproof Full Kit

Blue Double-Sided Neon Flex | 8x16mm | 220–240V AC | 120 LEDs/m

Our Blue LED Neon Flex throws a deep, saturated blue glow for bar, club and event accents, branding and logo lighting, and cool architectural feature lines. It runs at 120 LEDs per metre and lights from two faces, so the run reads clearly from two viewing directions — ideal for free-standing or suspended signs, lettering seen front and back, and balustrades lit on both sides. This is a fixed single colour, built for feature and signage work rather than general room lighting.

The 8x16mm body bends horizontally and cuts every 1 metre. An SMD 2835 chip across both faces gives an even, dot-free glow with no visible hotspots. It draws 9W per metre — a little more than a single-side strip because it lights from two sides — and lasts around 30,000 hours. Compared with traditional glass neon, it uses up to roughly 80% less power.

We cut the flex to length from a 50-metre roll and prepare each run to your measurements. Every run carries a 1-year warranty for indoor and outdoor use when properly sealed and installed. It ships with a UK plug, rectifier cable and end cap. The plug and switch are not waterproof, so house them in a dry, sealed enclosure when used outdoors.

Rated IP65, this neon flex suits indoor use and light outdoor settings where only mild splashes or moisture are present, such as covered patios or sheltered facades. It is not built for extreme weather or high-exposure areas. Do not use it near swimming pools, saunas, bathrooms, or underwater. For outdoor runs, apply heatshrink tubing and silicone sealant thoroughly at the end cap and front connection to block water ingress.

In the package:

• 1 x LED Neon Flex
• 1 x Pack of Clips (1 clip per metre)
• 1 x UK plug with rectifier cable
• 1 x End cap

Important Installation Notice: This product is not suitable for recessed outdoor installs on the ground or any surface exposed to direct water or heavy weather. For those applications, use IP67 or IP68-rated neon flex, which is designed for outdoor recessed use and gives higher protection against water and the elements. Any modification or improper use voids the warranty. In particular, hardwiring this light is not supported and will invalidate the warranty — it must run from the supplied plug. If you need a hardwired installation, choose one of our DC voltage neon flex ranges (12V, 24V or 48V), which are built for that purpose.

If you have any questions or need help choosing the right product for your project, contact our team at sales@atomled.co.uk.

Specifications

• Colour: Blue
• Emission: Double-sided (lights from two faces)
• Voltage: 220–240V AC (mains)
• Power: 9W per metre
• LEDs per metre: 120
• LED chip: SMD 2835
• CRI: >80
• Dimensions: (W)8mm x (H)16mm
• Cut points: every 1 metre
• Average LED life: 30,000 hours
• Warranty: 1 year
• IP rating: IP65 (indoor and limited outdoor use)
• Dimming: Yes